
Brake caliper replacement in Cedar Rapids, IA
A brake caliper is the clamp that holds the pads and squeezes them against the rotor, and replacing calipers is part of our brake repair work.
Call the shop, during shop hours, on the number below.
Key takeaways
Calipers sit beside pads and rotors in the brake repair we do.
Calipers, pads and rotors are the three parts of the disc brakes we replace.
What a brake caliper does and what it is made of
The caliper holds the brake pads. When you press the pedal, brake fluid pushes a piston in the caliper and the caliper squeezes the pads against the rotor, and that clamping force slows the wheel. Calipers are usually made of cast iron or aluminum, with a steel or phenolic piston inside.
Which brake calipers fit your car, and which are best
A caliper has to match the vehicle and the wheel it goes on, front or rear and left or right, so which caliper fits depends on the make, model and brake setup. No caliper is best for every car.
The brake-part brands we use or sell are NAPA, APSG, AutoZone, Bosch, Akebono, Brembo, ATE, Centric, Raybestos and Wilwood. We do not rank the brands.
How hot brake calipers get
Calipers run warm after ordinary stops and very hot after hard or repeated braking, such as a long downhill, so the temperature depends on how the car is driven. This page gives no figure. One wheel that is much hotter than the others after a drive can mean a caliper that is sticking.
Areas we serve
In Cedar Rapids
- Cedar Rapids, where the shop is.
- Downtown, Cedar Rapids.
- 1st Avenue, Cedar Rapids.
Around Cedar Rapids
- Hiawatha: about 5.1 road miles from the shop.
- Fairfax: about 7.1 road miles from the shop.
- Marion: about 7.3 road miles from the shop.
- Ely: about 9.9 road miles from the shop.
- Shueyville: about 10.1 road miles from the shop.
- Swisher: about 10.4 road miles from the shop.
- Walford: about 11.0 road miles from the shop.
- Atkins: about 12.7 road miles from the shop.
- Solon: about 16.9 road miles from the shop.
- Mount Vernon: about 17.1 road miles from the shop.
- Center Point: about 18.0 road miles from the shop.
- North Liberty: about 18.2 road miles from the shop.
- Lisbon: about 18.7 road miles from the shop.
- Tiffin: about 20.2 road miles from the shop.
- Central City: about 21.9 road miles from the shop.
- Urbana: about 23.0 road miles from the shop.
- Coralville: about 23.8 road miles from the shop.
- Anamosa: about 25.8 road miles from the shop.
- Mechanicsville: about 25.8 road miles from the shop.
- Iowa City: about 27.3 road miles from the shop.
- Marengo: about 31.3 road miles from the shop.
- Stanwood: about 31.5 road miles from the shop.
- Vinton: about 34.0 road miles from the shop.
- West Branch: about 36.3 road miles from the shop.
Why Arcadia Tire Co.
- 40 years of automotive experienceBetween the shop workers
- In business since 2018
- Open Saturdays 1pm-5pm
- 30-day guarantee
- Wheelchair-accessible entrance and parking lot
Frequently asked questions
- Where can I get a brake caliper replaced near me?
- A sticking or leaking caliper is replaced at the shop, right outside downtown Cedar Rapids, half a block from Highway 380. The address is 507 1st Ave SW.
- How much does it cost to replace a brake caliper?
- The cost depends on the vehicle, the caliper it takes, and whether the pads, the rotor or a brake line need work at the same time. The price is not on this site. Call (319) 200-2002 and ask.
- How do I know a brake caliper is bad, and when does it need to be replaced?
- Common signs are the car pulling to one side when you brake, a burning smell or one wheel much hotter than the others after a drive, pads wearing unevenly, or brake fluid leaking near a wheel. A caliper is replaced when it sticks, leaks or seizes.
- What causes brake calipers to stick or seize?
- Usually corrosion. Rust and dirt on the slide pins, or a piston seal that has worn and let moisture in, keep the caliper from releasing fully, so the pads drag on the rotor.
- How long do brake calipers last?
- There is no set life. A caliper is not a wear part the way a pad is, and it lasts until corrosion, a worn seal or a seized piston stops it working, which depends on the vehicle, the climate and the roads it sees.
- When should brake calipers be cleaned or greased?
- A caliper has no routine cleaning or greasing schedule. Its slide pins and the places where the pads sit are usually cleaned and lubricated when the pads are replaced, which is when stiffness or rust there shows up.
- What is the difference between brake calipers and brake pads?
- Pads are the friction material that wears down with every stop. The caliper is the clamp that presses them; it is not a wear part in the same way, and it is replaced when it sticks, leaks or seizes.

Need tires or a repair in Cedar Rapids?
Call (319) 200-2002, Mon-Fri 10am-6pm and Sat 1pm-5pm, or request an estimate online.
